Mission™ 0703512 End Cap, 3 in, Rubber

3" Flexible rubber end caps with hose bibb for capping Cast Iron or Plastic pipe ends. Directs water flow and drainage during and after testing. Eliminates need to fill DWV system from roof vent. Needs no plastic disc or liner to resist dirt, water or ozone. Recommended for above ground installations. Easy to install and reuse.

Mission™ End Cap, 3 in Fitting, Rubber

• MISSIONMADE™ products are easy-to-install and reuse
• Synthetic rubbers permit considerable distortion withstanding tension and compression, more pliable, easier to install in cold weather applications than elastomeric PVC caps
• Tight fitting internal cone wedges inside pipe, balancing outward strains against steel clamp, sealing O-rings under clamp prevent pipe end slippage for a reinforced joint seal
• Increased band tension secures pipe end, forming a watertight seal, axially tapered design distributes and dissipates internal stresses, strong, molded "ASTERISK" braces end cap against head pressure during testing
• Stainless steel components resist corrosion in various environments
• For permanent or temporary clean outs, independent clamp tightening adapts to different outside pipe diameters
• Synthetic rubber cap resists ultraviolet rays, ozone, fungus growth, natural soil erosive properties and normal sewer gases
• 301 Series stainless steel worm drive clamp
• Molded, one piece, elastomeric sealing cap
• Brass Pro-Line Series faucet hose bib
• Sillcock brass valve with 1/2 in inlet and 3/4 in male hose thread outlet