Mission™ BAND-SEAL® 0706028 End Cap, 6 in, For Use With: Capping Cast Iron, Plastic or Steel Pipe Ends, Rubber

Flexible, rubber end caps for capping Cast Iron, Plastic, or Steel pipe ends. Non-pressure, gravity flow applications only. Recommended for above ground installations. Easy to install and reuse.

Mission™ End Cap, 6 in Fitting, 1000 psi Tensile Strength, For Use With: Capping Cast Iron, Plastic or Steel Pipe Ends, Material Standard: ASTM C425, Rubber, 6.35 in OD, Additional Information: 5/16 in Hex Screw

• Secure - tight fitting internal cone wedges inside pipe, balancing outward strains against steel clamp, sealing O-rings under clamp prevent pipe end slippage for a reinforced joint seal
• Anti-corrosive stainless steel components resist corrosion in a variety of environments
• Adaptable, for permanent or temporary clean outs, independent clamp tightening adapts to different outside pipe diameters
• Easy MISSIONMADE™ products are easy to install and reuse
• Leak-proof, increased band tension secures pipe end, forming a watertight seal, axially tapered design distributes and dissipates internal stresses, strong, molded asterisk braces end cap against head pressure during testing
• Resilient - synthetic rubbers permit considerable distortion withstanding tension and compression, more pliable, easier to install in cold weather applications than elastomeric PVC caps
• Durable synthetic rubber cap resists UV rays, ozone, fungus growth, natural soil erosive properties and normal sewer gases

• Submittal https://assets.unilogcorp.com/267/ITEM/DOC/Mission_0705020_Submittal.pdf
• Catalog https://assets.unilogcorp.com/267/ITEM/DOC/Mission_0701011_Catalog.pdf
• Specification Sheet https://assets.unilogcorp.com/267/ITEM/DOC/Mission_0701011_Specification_Sheet.pdf
• Submittal https://assets.unilogcorp.com/267/ITEM/DOC/Mission_0705020_Submittal.pdf