Easy Radiant Works The Heatwave GH40N Garage/Shop Heater, 120 V, Steel

The Safe, Efficient and Affordable Solution for Heating your Garage or Workshop. Perfect for Smaller Garages & Workshops With Lower Ceilings. At 40,000 BTUH, 8' in length, and only 8 3/4" from bottom to top, the Heatwave can fit in smaller shops easily, and can be installed in building with ceilings as low as 8'. Perfect for garages and workshops, the Heatwave can also be used anywhere that space constraints make other heating equipment difficult or impossible to use. The Heatwave comes factory assembled and ready to hang right out of the box - everything you need is included for easy installation. 5' of concentric venting, side wall vent termination, a 24V thermostat, flexible gas connector, and hanging chain are provided. Exhaust and air intake venting are run through a 5" dia. side wall concentric duct for a clean, sleek installation. 5' vent extension and 90 degree vent elbows are available.

Easy Radiant Works Garage/Shop Heater, 120 V, 1 A, 60 Hz, 1 ph Phase, Steel, 8 ft L x 16 in W x 9 in D, 40000 Btu/hr, Additional Information: Natural Gas Fuel

• 40,000 BTUH
• Natural gas (model GH40N) and propane (model GH40P) fired models built to order with no field conversions required.
• Reliable electronic hot surface ignition.
• Built with 100% North American made electronic controls.
• Continuous combustion monitoring with three to five ignition trials before 100% safety lockout.
• Totally enclosed blower motor with internal thermal overload protection. Blower motor is externally mounted for ease of accessibility and to simplify intake air connection (4" combistion air intake duct adapter comes standard).
• Dual air proving switches monitor combustion air and exhaust airflow for safety.
• Flame observation port to visually observe combustion.
• Factory ready to accept either 24V or 120V controls.
• Emitter tubes are 3" diameter, 16 gauge North American steel.
• Primary combustion tube made of high temperature, high emissivity specialty alloy.
• Secondary tubes constructed of 16 gauge carbon steel for high emissivity.
• Swedged tube for ease of installation – no couplers or clamps required at joints.
• Emitter tubes provided with a 20 year burnout guarantee.
• Highly efficient, wide angled aluminum reflectors – engineered to reflect maximum radiant energy over the largest effective area possible.
• Highly polished material for increaded reflectivity.
• Steel hangers with suspension points for both flat and angle mounting of reflectors.

• Instruction/Installation Manual https://assets.unilogcorp.com/267/ITEM/DOC/Easy_Radiant_Works_GH40N_Instruction_Installation_Manual.pdf
• Instruction/Installation Manual https://assets.unilogcorp.com/267/ITEM/DOC/Easy_Radiant_Works_GH40N_Instruction_Installation_Manual.pdf