FRIGIDAIRE® G7SD FG7SD090D-35C1 Gas Furnace, 90000 Btu/hr Input BTU, 95 % AFUE, Upflow, Horizontal

The high efficiency upflow gas furnace may be installed free standing in a utility room, basement or enclosed in an alcove or closet. Upflow/horizontal units come ready for upflow or horizontal application. The extended flush jacket provides a pleasing "appliance appearance". Design certified by CSA for application in Canada and the United states. This furnace series is approved and certified by the SCAQM and the SJVAPC Districts in the state of California under each districts mitigation fee plan for shipment into and sales in both districts. For California installations in SCAQMD only: This furnace does not meet the SCAQMD Rule 1111 NOx emission limit (14 ng/J) and thus is subject to a mitigation fee of up to $450.

FRIGIDAIRE® Gas Furnace, Series: G7SD, 90000 Btu/hr Input BTU Rating, 95 % AFUE, Configuration: Upflow, Horizontal, 34-1/2 in H x 21 in W x 28 in D Cabinet Dimensions, 3 - 5 ton

• 100% fired and tested - all units and each component are tested on the manufacturing line
• Best packaging in the industry - unique corner post design assures product will arrive to the homeowner dent-free
• 30 sec blower delay at start-up - assures a warm duct temperature at furnace start-up
• Adjustable blower-off settings (60, 90, 120 and 180 sec)
• 30 sec post purge - increases life of heat exchanger
• Hot surface igniter - innovative application of a silicon nitride igniter
• Utilizes proven SmartLite® technology
• Color-coded wire harness - designed to fit the components, all with quick connect fittings for ease of service and replacement
• Flexible category IV venting system, may be vertically or horizontally vented using either a one-pipe or two-pipe system for maximum flexibility in installation
• High static blowers - all models equipped with high static blowers
• Low boy height - easy to apply in low ceiling applications, works well with taller high SEER coils, easier to handle and install
• Tubular primary heat exchanger - heavy gauge aluminized steel heat exchanger assures a long life
• 60 sec cooling cycle blower-off delay (TDR) - increases cooling performance when matched with a Nortek Global HVAC coil
• High efficiency blower kits - maximize efficiencies and provide better temperature control, humidity control and air distribution
• Multi-speed direct drive blower - designed to give a wide range of cooling capacities
• Switches on PCB, provide ultra easy motor speed selection
• LP convertible - simple burner orifice and regulator spring change for ease of convertibility
• Diagnostic lights for easy troubleshooting without counting flashes: dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes
• Incorporates integrated control board - incorporates connections for electronic air cleaner and humidifier
• Two piece door design - enhances furnace appearance and uses captured screws to prevent loosing door screws

• Specification Sheet https://assets.unilogcorp.com/267/ITEM/DOC/Frigidaire_FG7SD072D_35C1_Specification_Sheet.pdf